November 3, 2010How can i make modern diamond plate running boards work with 1952 GMC Fenders on the back and custom made bedsides?
Forums : Aftermarket : Runningboards for my conversion?!?!?!?!? (463 Views)
Subscribers : MetalMikeJr
Horse power makes you go fast but Torqe is what makes you swallow ur tounge and thrust ur eye balls into the back of your head
November 3, 2010buy some diamond plated steel and start cutting and welding
November 4, 2010How I envision them....I`d get the diamond plate running boards that extend from the front wheel well to the rear wheel well (one piece design) for a reg cab long box (assuming they are long enough - should be on your SWB truck), hang them up front and off the frame as you would on a standard application. Then trim them to the contour of the fender (not knowing how low your fender will be on the truck). Either butt them up to and fasten to fender if the fenders hang below body line or just tuck then under by 1/2" or so if the bottom of the rear fender is flush with the bottom body line of the truck!?!?
Good Luck on your project!